#Loudness equalization good or bad how to#

Amplifying the 8-16 kHz range makes it easier to hear overtones and upper harmonics, something our brains perceive as clarity. If you indelicately add too much emphasis here, it can result in what some refer to as a вЂњmuddyвЂќ sound, cut too much and it might start sounding вЂњhollow.вЂќДЄdding emphasis around 2kHz usually makes the attack of picked guitar strings easier to hear. As you can see there is a lot going on in that region (and we only showed a few examples). One area that you should pay special attention to is the range between 250-1,000Hz. The fundamental frequencies of guitars and both male and female vocals (with obvious differences) can be found roughly between 80-1,000Hz.

#Loudness equalization good or bad how to#

And we mean that both physically and psychologically.В Moral of the story is that things sound different to each person, so everything from here on out, regarding how to EQ, is just a guideline to help find what works best for you. Trust your ear: sound is a very personal experience. Done correctly, this will give you the same result while keeping everything below the distortion threshold. In short, itвЂ™s better toВ cut the frequencies that you want less of than boosting the ones you want to hear more of. If you boost too much you can introduce distortion, which defeats the object of what weвЂ™re trying to accomplish here. This is called cutting.Д¬utting is usually a better approach than boostingДЄs a general rule of thumb (actually itвЂ™s more like a rule), cutting is better than boosting. On the flip side, you can also decrease the output of a specific frequency range for something that you want to hear less of. It makes sense if you think about it, youвЂ™re just boosting the output of something that you want to hear more of.

The first is to make the target frequency louder by raising the level (amplitude) of a specific range. There are two ways to tweak your sound when learning how to EQ. Is there a technique to creating a custom EQ?